Eurovac Solutions
Body Shop Specialized Repair Equipment
![](https://www.eurovac.com/us/wp-content/uploads/2014/11/Aluminum-Repair.jpg)
OEM Approved Equipment:
Body Repair Certification
EII – Wet Mix Dust Collector
PART # SYS-050-18300300
- Wet mix dust collector, fabricated from 14 gauge stainless steel which is then thermoset powder coat painted.
- Manual water level system whereby the customer fills the unit with more water when the water level gets to a certain level marked on the site glass.
- Manual drain valve located at the bottom of the separator.
- Initial stainless steel venturi entry for deep penetration into the water, secondary baffles to completely mix the dust particulate with the water whereby no after dry/hepa filter is required.
- Site glass to visually check the water level.
- Automatic low water shut down sensor which prevents the unit from operating if water is not set at proper levels.
- A time delay switch is provided to prevent the start of the dust-producing process (sanding tools) until the collector is in complete operation.
- An off delay time switch is provided which allows the system to run for a set amount of time once the sanding has stopped. This ensures all dust in the hose reaches the collector.
- System includes (2) 25’ lightweight anti-static hose with attached airline
*Patent Pending
EI – Central Wet Mix Dust Collector
- 5, 10 & 20HP regenerative motors are available depending on your needs.
- Electrical control panel , automatic water level control system and automatic hydrogen relief valve. Includes magnetic starter, overload protection with panel mounted stop/start and remote stop/start capability.
- Vacuum relief valve mounted between the separator & pump.
- Wet scrubber, fabricated from 12 gauge steel which is epoxy powder coat painted and treated with zinc oxide and rust inhibitor. (Optional upgrade to stainless steel).
- Automatic water level control system via an ultra sonic probe situated in a reservoir of “quiet” water.
- Manual drain valve located at the bottom of the separator.
- Initial stainless steel venturi entry for deep penetration into the water, secondary baffles to completely mix the dust particulate with the water. Final stainless steel mist eliminator.
- Site glass to visually check the water level.
- Relief valve set to automatically open when system is shut down for exhausting hydrogen gas build-up in an aluminum application.
STRUCTURAL REPAIR CERTIFICATION
Central Fume Extraction System
PART # SYS-000-FUMEARM0
- 1.5 HP Fan set to produce 900 CFM at 8” W.C.
- 6” x 4m (13.12’) articulated arm (other sizes available)
- Wall mounting bracket
- Self supporting joints and flexible hoses for easy placement with smooth bore tubing for unimpeded air movement
Portable Fume Extraction System – “Box Air”
PART # SYS-070-45006100
- 700 CFM @ Hood
- Spark Trap
- Large Wheels
- Cartridge Filter
- Single phase operation
- Arm Diameter: 6”
- Arm Length: 7
Portable Fume Extraction System – “Rollout”
PART # SYS-070-45106100
- 1 HP Fan set to produce 700 CFM at 8” W.C.
- Three stage high end filtration; aluminum mesh pre-filter which protects the cartridge filter from sparks and prefilters the air, followed by a spun bond polyester cartridge filter, and a final carbon after filter.
- Manual compressed air pulse jet cleaning.
Body Shop Specialized Repair Equipment Products
Photo Gallery
Warning: Invalid argument supplied for foreach() in /home/eurovac/public_html/us/wp-content/themes/eurovac/single-solutions.php on line 292