Eurovac Products

EIII Double Turbine Central Detail Vacuum Systems have horse powers suited for up to 50 technicians vacuuming at the same time.  EIII Systems are typically used for six to thirty detail bays with a drop at each car door and a longest run of up to 250’.  The EIII Double Turbine Central Vacuum is an industrial grade system designed to run all day, every day in the most demanding detail operations.

Application:   

• 6 to 50 Tech Detail Vacuum System

Part Numbers: 

• SYS-102-6530BS0B:  Double 10HP System
• SYS-152-7038BS0B:  Double 15HP System
• SYS-202-7038BS0B:  Double 20HP System
• SYS-252-7542BS0B:  Double 25HP System
• SYS-302-7548BS0B:  Double 30HP System
• SYS-402-7554BS0B:  Double 40HP System
• SYS-502-7554BS0B:  Double 50HP System
• SYS-602-7560BS0B:  Double 60HP System
• SYS-752-7560BS0B:  Double 75HP System

Equipment Specs:   

• Blower:  QTY 2 – Centrifugal Multi-Stage Turbine Blowers (energy efficient and rated for 20,000 hours of continuous operation)
• Filtration: 30” to 60” Cyclonic filter separator with after bag filters
• Canister: 26 to 45 Gal plastic tote canister
• Electrical: 208-240, 460 and 575 volts. 3 phase, 60 hertz Premium Efficiency TEFC Motors
• Blower Relief: QTY 2 – Manual ball valves for ensuring blower does not go into “surge”
• Inlet:  5″OD to 12”OD

System Performance:                                            

• Vacuum – 6”Hg (81.6″WC) to 8”Hg (108.8”WC)
• Flow – 600 CFM to 3800 CFM

Optional Additions:   

• Controls:  A wide variety of control options are available for EIII Systems, from On/Off Starters to VFD’s (Variable Frequency Drive).  For double turbine systems, a lead/lag control system should be considered as it allows one turbine to start operation and the other to kick in when additional demand is required.
• Check Valves: QTY 2 – Check valves which allow each turbine to be isolated where by only vacuum is produced if that specific turbine is operating

Includes:

• QTY 2 – Silencers, Throttling Valves, Manual Ball Relief Valves, 4 Anti-Vibration Pads, Wedge Anchors & 2 Caps (for potential unused inlet/outlet)