Eurovac Products

The EI (1 Filter) Central Welding Vacuum System offers high vacuum performance for one to two technicians vacuuming or using source capture welding guns.  The system is typically connected with galvanized tubing to conveniently located wall or hanging drops with a longest run of no more than 200’.

Application:   

• 1 & 2 Tech Welding Vacuum System

Part Numbers: 

• EIC-W05-24132003:  5HP System
• EIC-W10-24132003:  10HP System

Equipment Specs:   

• Design:  Skid mount system (for easy transportation) which comes pre-wired from panel to pump and to the pulse jet cleaning
• Blower:  Regenerative Blower set to run for 20,000+ hours of continuous use
• Filtration: Cyclonic filter separator, 1 after nanofiber cartridge filters (220 sq. ft. filter media) (99.93% efficient at 3 microns or larger) and final automatic pulse jet cleaning
• Canister: 30 Gal
• Electrical: 208-240, 460 and 575 volts. 3 phase, 60 hertz
• Inlet:  3″OD

Control Panel Specs:

• NEMA 4 Enclosure (Indoor/Outdoor)
• Start/Stop
• Overload Protection
• Run Light
• 120v Step Down Transformer (ie: Control remote on/off switches)
• 24VDC Sequential On Demand Auto Pulse Jet. Includes Proportional Type “On Line” Cleaning, “Off Line” Cleaning
• Filter Differential Pressure (dp) Display
• Dirty Filter Fault Shutdown/Light (c/w external reset)
• General Pulse Jet Fault Light

System Performance:                                            

• 5HP System
• Vacuum – 100″WC
• Flow – 160 CFM

• 10HP System
• Vacuum – 100″WC
• Flow – 310 CFM

Includes:

• Silencer, Exhaust Cap, 4 Anti Vibration Pads & Wedge Anchors
• Pre-wiring from panel to pump
• Air Filter Regulator (For Pulse Jet Cleaning)

Not Included:

• Electrical Disconnect

Optional Additions:

• HEPA Filtration (HEP-R17-1B0300RP)